na3D
400 products
-
Add to FavouritesGT2 pulley - black anodized
Black smooth pulley corresponding to the dimensions of the 20-tooth GT2 pulley - width 6 mm, hole 3 mm.
Sold out
2,83 €
-
Add to FavouritesSet of travel rods Rebelix x2
Set of hardened travel rods for assembling 3D Rebelix X2 printers.
Sold out
20,46 €
-
Add to FavouritesPower Panic v0.4
Connector before the source for monitoring a decrease in network connection. Supports 12 and 24 V.
Sold out
20,46 €
-
Add to FavouritesPrusa MMU Control V2
Control board for multimatcher printing. Prusa mm Control
Sold out
40,96 €
-
Add to FavouritesCR10 heatblock cube
Replacement aluminum cube (Heatblock) for extruders on Creality printers.
Sold out
3,24 €
-
Add to FavouritesU604ZZ - bearing with groove for filament pressure
Bearing with groove for filament pressure. Most often used in the MK8 extruder. (The product can be ordered after 1 piece, the photo is only illustrative.)
Sold out
1,19 €
-
Add to FavouritesMagnetic print pad with magnetic sticker 220 x 220 mm
Magnetic printing pad with dimensions of 220 x 220 mm for better adhesion of prints. It is a two-part set, where a detachable magnetic pad guarantees easier removal of the printed products.
Sold out
10,21 €
-
Add to FavouritesMotor connector - dual z
Motor connector - suitable for dual Z. Parallel connection of 2 engines to one output of the control board.
Sold out
2,01 €
-
Add to FavouritesFilament welding
Filament welding product available in two dimensions. Dimensions 1.75 mm and 3.0 mm. The welding product is used to connect the ends of the strings to make the most of the coil content.
Sold out
from 12,26 €
-
Add to FavouritesEnd sensor on PCB - endstop
Endstop end sensor in variant with or without pulley. Easy to use, with an integrated connector on one side.
Sold out
1,60 €
-
Add to FavouritesSpare motor for 3D pen
Spare engine for 3D pens.
Sold out
6,11 €
-
Add to FavouritesBall bearing F623ZZ
Bearing F 623 ZZ with one row of balls in deep orbits. It transmits radial and axial load. Size 3 x 10 x 4 mm. (The product can be ordered after 1 piece, the photo is only illustrative.)
Sold out
1,02 €
-
Add to FavouritesBrass brush
Brass brush for cleaning and removing peeling dirt from print strings from nozzles, hotends, heated cubes, pads, etc.
Sold out
3,24 €
-
Add to FavouritesCork shock absorber for step engines 3 mm
Cork shock absorber for step engines with NEMA17 flange measures 42 x 42 x 3 mm. It is used to reduce the transmission of vibration to the printer frame, reduce heat transfer from hot engines to the plastic part of the frame, reduced resonance from the engine, fewer sounds from the printer.
Sold out
1,19 €
-
Add to FavouritesBelt tensioner on profile 2020
Belt tensioner in axis x 2020. It is a kit. Available in silver and black colors. (The product can be ordered after 1 piece, the photo is only illustrative.)
Sold out
14,31 €