Tools
-
Kettle pliers with round tips. Suitable for wire and fine workshop work.
Availability: In stock 10 to 100 pcs
3,36 €
-
Using these small combinations, you can easily remove the supports or pull the rest of the string out of the extruder.
Availability: Sold out
2,94 €
-
With a torque wrench, you can tighten the nozzle quickly and accurately. You will improve the quality of the hotend assembly and prevent unwanted filament leakage around the thread. Using a preset torque, always tighten the nozzle with the same force.
Availability: Sold out
34 €
-
Brass brush for cleaning and removing peeling dirt from print strings from nozzles, hotends, heated cubes, pads, etc.
Availability: In stock 100 to 500 pcs
3,36 €
-
The brass brush is used to clean and remove peeling dirt from print strings from nozzles, hotnds, heated cubes, pads, etc.
Availability: Sold out
2,51 €
-
The set is designed especially for accurate plastic trimming. Suitable especially for PLA, PETG, ABS, PEI, Peek, carbon fiber, as well as stainless steel, aluminum alloy, rubber. The product is available in three variants: only knife / spare blade / knife and spare blades.
Availability: In stock <10pcs
from 8,47 €
-
The tweezers are suitable for removing the filament from the hot nozzle, or pulling supports from small spaces.
Availability: In stock <10pcs
1,66 €
-
The tweezer is suitable for removing the filament from the hot nozzle, or pulling out support from small spaces.
Availability: In stock 10 to 100 pcs
1,66 €
-
Filament welding product available in two dimensions. Dimensions 1.75 mm and 3.0 mm. The welding product is used to connect the ends of the strings to make the most of the coil content.
Availability: In stock <10pcs
from 12,72 €