Resin was specially developed for 405 Nm LCD printers. The cure time of one layer is 7 seconds for Shuffle and 1.5 seconds for Sonic series. Resin is suitable for printing 3D characters and product prototypes.
Do not rinse printed models under running water so that the chemicals do not get into the environment. This resin is as dangerous as the other resin.
Warning and safety instructions
Signal word : Danger
Precautionary statements:
P101 - If medical advice is needed, have product container or label at hand.
P102 - Keep out of reach of children.
P201 - Obtain special instructions before use.
P261 - Avoid breathing dust/fume/gas/mist/vapours/spray.
P272 - Contaminated work clothing should not be allowed out of the workplace.
P273 - Avoid release to the environment.
P280 - Wear protective gloves/protective clothing/eye protection/face protection.
P302+P352 - IF ON SKIN: Wash with plenty of water.
P305+P351+P338 - IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P310 - Contact your doctor/poison control centre immediately.
P362+P364 - Take off contaminated clothing and wash it before reuse.
P391 - Collect spillage.
P405 - Store locked up.
P501 - Dispose of contents/container according to local/national regulations.
Hazard statements:
H315 - Causes skin irritation
H317 - May cause an allergic skin reaction
H318 - Causes serious eye damage.
H361fd - Suspected of damaging fertility. Suspected of damaging the unborn child.
H410 - Very toxic to aquatic life with long lasting effects
66,32 €