DIMAFIX PEN (90 ml), is a new product which has the same adhesive properties as DimaFix spray, which is a very effective adhesive spray for improved adhesion of surface depending on the temperature - the adhesiveness increases above 65 ° C. After printing, after cool pad, the model can be easily removed again from the press pad. DimaFix Pen is unlike DimaFix spray liquid. Does not therefore no gas and is environmentally friendly. During the press does not smell. Adhesion spray relative to the substrate temperature: strong> p>
p>
p>
It lasts more than 100 applications. It is soluble in water and thus easy to clean.
Manual:
strong> first Clean the print area of the printer. Make sure that the press pad temperature is below 50 ° C!
second Adhesive stick Dimafix Pen few seconds shake, then apply it by spraying onto (nevyhřátou) print substrate from a distance of about 30 cm.
third Wait a few seconds before the surface dries before Win substrate to the desired temperature. The temperature according to the selected dial-type filament and working temperatures Dimafixu see table below. The product starts to work optimally only at a temperature above 65 ° C.
When heated pad, you can start printing. Strong>
4th After printing, the 3D object wait until the print bed is cooled (T bed sub> & lt; 65 ° C). Carefully remove the printed model of the press pad. P>
20 ° C - 60 C strong> td>
None optimized adhesion properties td>
Tr>
60 ° C - 75 ° C, strong> td>
Moderate adhesion for simple geometry td>
Tr>
75 ° C - 95 ° C, strong> td>
High adhesion, for long and complex geometry prints td>
Tr>
Over 95 C strong> td>
Very high adhesion, for long and complex geometry prints td>
Tr>
Tbody>
Table>
New product question
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
This website uses cookies. More info