- ATmega2560 and FT232 processor compatible with the Arduino MEGA are compatible with all firmware classes RAMPS li>
- The firmware can use the same configuration as ramps1.4 li>
- 3 x connector for a temperature sensor (thermistor) li>
- 5 x stepper motor controller with easy adjustments microsteps li>
- 4 x power MOSFET PWM outputs with a voltage selection for the main power supply. (Bed, Extruder0, Extruder1, Fan) li>
- 4 layer PCB, to optimize heat dissipation li>
- 3 x 5V output, 3 x 12V output interface li>
- 6 end connectors (signal V +, V-) Xmin / Xmax / Ymin / Ymax / Zmin / Zmax li>
- fuse for protection of shorting li>
- Dimension: 145x85mm li>
Ul>
Note:
This product may require professional installation is not separately functioning altogether. Strong> p>