Other electronics
-
0,21 €
-
from 27,61 €
-
Board with 8 diodes for the smoothness of the stepping signal. Using this plate you will get a higher quality print surface. Designed for DRV8825 drivers - you may not notice the difference on others.
Availability: Sold out
4,21 €
-
External MOSFET for better pad temperature control. Thanks to the module, you avoid a lot of heating problems. Maximum current 30A. Use for 12 - 50 V.
Availability: In stock 10 to 100 pcs
8,47 €
-
Extension cables 2 -pin, 3 -pin and 4 -pin available in two lengths. The cable is fitted with a dupont connector - female - female.
Availability: In stock <10pcs
1,66 €
-
Mounting profile for BLTOUCH pad calibration sensor for Creality printers Ender 3, Ender 5, Ender 3 PRO, CR-10. Mounting parts are available in three variants - basic, with programmer, cable only.
Availability: In stock 10 to 100 pcs
from 4,21 €
-
6,34 €
-
Suitable for autolevelling. An alternative to an induction sensor. At the end of the servo arm, a mechanical end sensor is placed that "taps" the mat.
Availability: In stock <10pcs
4,21 €
-
Expansion module for RAMPS 1.4 to connect additional fans. Use, for example, for cooling chambers, printing, hotend, etc. The module requires a FW update.
Availability: In stock <10pcs
8,47 €